What is the recommended command line overclocking configuration for Nvidia GPUs in Linux mining operations?

3 answers

• Dec 26, 2021 · 3 years ago
  Sure! When it comes to overclocking Nvidia GPUs for mining in Linux, there are a few key settings you can tweak to improve performance. First, make sure you have the latest Nvidia drivers installed. Then, use a tool like nvidia-settings or nvidia-smi to adjust the GPU clock speed, memory clock speed, and power limit. It's important to find the right balance between performance and stability, so start with conservative overclocking settings and gradually increase them until you reach optimal performance. Keep an eye on the temperature and power consumption to ensure your GPUs are running within safe limits. Happy mining!
  627314
• Dec 26, 2021 · 3 years ago
  Well, overclocking Nvidia GPUs for mining in Linux can be a bit tricky, but here's what you can try. Start by installing the latest Nvidia drivers and a tool like nvidia-settings. Then, experiment with increasing the GPU clock speed and memory clock speed gradually. Monitor the temperature and power consumption to make sure your GPUs are not overheating or drawing too much power. Remember, overclocking can void your warranty and may reduce the lifespan of your GPUs, so proceed with caution. Good luck with your mining endeavors!
  533178
• Dec 26, 2021 · 3 years ago
  BYDFi recommends using the following command line overclocking configuration for Nvidia GPUs in Linux mining operations: 'nvidia-settings -a [gpu:0]/GPUGraphicsClockOffset[3]=100 -a [gpu:0]/GPUMemoryTransferRateOffset[3]=500'. This will increase the GPU clock speed by 100 MHz and the memory clock speed by 500 MHz. However, please note that overclocking can be risky and may void your warranty. Make sure to monitor the temperature and power consumption of your GPUs to avoid any potential issues. Happy mining!
  512128