What are the recommended settings for using the Fury X 2 in a cryptocurrency mining rig?

3 answers

• Dec 27, 2021 · 3 years ago
  To get the best performance out of your Fury X 2 in a cryptocurrency mining rig, there are a few recommended settings you can try. First, make sure you have the latest drivers installed for your graphics card. Then, adjust the power limit and core clock settings to find the optimal balance between performance and power consumption. You may also want to experiment with memory clock settings to see if it improves your mining efficiency. Finally, consider using mining software that is optimized for your specific card, as this can further enhance your mining performance.
  573287
• Dec 27, 2021 · 3 years ago
  When it comes to mining with the Fury X 2, it's all about finding the right balance. You want to maximize your hash rate while keeping power consumption in check. Start by adjusting the power limit and core clock settings. Increasing the power limit can give you a higher hash rate, but it will also consume more power. Finding the sweet spot where you get a good hash rate without pushing the card too hard is key. Additionally, make sure you have adequate cooling in your mining rig to prevent overheating. Remember, mining can put a lot of stress on your hardware, so it's important to monitor temperatures and adjust fan speeds accordingly.
  644215
• Dec 27, 2021 · 3 years ago
  When it comes to optimizing the Fury X 2 for mining, BYDFi recommends using the following settings: set the power limit to 50%, adjust the core clock to +50 MHz, and set the memory clock to +500 MHz. These settings have been found to provide a good balance between performance and power consumption. However, keep in mind that every mining rig is unique, so you may need to tweak these settings based on your specific setup and the cryptocurrency you're mining. It's always a good idea to monitor your rig's performance and adjust settings accordingly to maximize your mining efficiency.
  587147